Support and Downloads

General

Inspection Checklist for the Power Cord and Power Plug

 

Contact the local Canon Service Centres if any of the following problems are found:

  • There are burn marks on the power plug. It is possible that tracking phenomena have started. This is a dangerous condition.
 
  • A power plug prong is deformed.
 
 
  • The power supply goes off and on when the power cord is bent.
 
  • There are cuts, cracks, or indentations on the power cord.
 
 
  • A portion of the power cord becomes hot.
   
 
   
 

Examples that may cause electric shock or fire and are dangerous:

  • Dust or debris has accumulated on the power supply outlet and power plug.
    (Recommendation: Turn the power switch off, disconnect the power plug, and remove dust and debris with a dry cloth.)
 
  • The connector on the device side is loose.
    (Recommendation: Push the connector firmly all the way in.)
 
 
  • Stress is being applied to the power cord.
    (Recommendation: Position the power cord so that it is not subjected to stress.)
 
  • Disconnecting the plug by pulling on the power cord.
    (Recommendation: Always disconnect the power plug by pulling on the plug rather than the cord.)
 
  • Connecting or disconnecting the power plug with wet hands.
    (Recommendation: Dry your hands completely with a towel, etc., before connecting or disconnecting the power plug.)
 
 
  • The power plug is loose.
    (Recommendation: Push the power plug firmly all the way in.)
 
  • The power cord is tied in a bundle.
    (Recommendation: Loosen the power cord.)
 
 
  • The power cord protrudes into a walkway.
    (Recommendation: Position the power cord so that it will not obstruct the walkway.)
 
  • The power cord is in front of a heater.
    (Recommendation: Position the power cord in a location that is not subjected to heat radiation.)
 
 
  • The product or table tap is at a location near water access.
    (Recommendation: Water is the enemy of electricity. Do not use electrical products at a location on which water may come.)
 
  • An excessive number of cords are connected. It is possible that the rated capacity of the table tap has been exceeded.
    (Recommendation: Do not connect an excessive number of cords.)